Skip to content
Orlando Gutter Co

Service

Gutter Replacement in Orlando

Taking down tired sectional or undersized gutter and rehanging the roofline properly.

Replacement is the most common gutter job in Orlando, and most of the time the reason is not that the old gutter failed structurally but that it was never sized or sloped for the roof above it. Builder-grade 5-inch on a house with big roof planes overflows in a summer downpour no matter how clean it is. Sectional gutter that has been resealed twice is on borrowed time at every lap. Spike-and-ferrule hangers pull out of fascia that has been wet and dry a hundred times. A replacement is the moment to fix the sizing and the outlet placement as well as the metal, because the labour is already being paid for and rehanging it correctly costs very little more than rehanging it the same.

What the scope covers

  • Old gutter, downspouts, and hangers removed and hauled off
  • Fascia inspected once the old run is down, with any soft board flagged before new metal goes up
  • Run resized where the roof area feeding it justifies going from 5-inch to 6-inch
  • Outlets relocated to where the water collects rather than reused from the old layout
  • Spike-and-ferrule hangers replaced with hidden hangers into sound wood
  • Downspouts re-routed away from walkways, driveways, and the foundation line
  • Drip edge condition checked at the roof edge while the gutter is off

Working out what your roof needs

Whatever the scope, the sizing question is the same one: how much roof drains into each run, and how fast the water arrives. Central Florida answers the second half unusually, with a one-hour, ten-year design depth of 2.91 inches downtown against sizing tables published at one inch per hour. The sizing guide works through the arithmetic, and the price estimator turns it into a ballpark figure.

Questions about replacement

How long do aluminum gutters last in Central Florida?

The aluminum itself is not usually what gives out. Coil and finish hold up well in this climate, and a straight run can look serviceable for decades. What ages is everything holding it: sealant at sectional laps, hangers in fascia that has been repeatedly soaked, and the fascia board itself. Systems that come down in Orlando are typically replaced for leaking joints, sagging runs, or capacity, not for corroded metal.

Do the gutters need replacing when the roof is replaced?

Not automatically, but the two jobs interact. Roofers often take gutter off or work around it, and drip edge is installed as part of the roof. Doing gutter immediately after a reroof means the new run gets hung against fresh drip edge and sound fascia, which is the ideal sequence. Doing it before a reroof risks the new gutter getting knocked about. If a roof is close to due, sequencing gutter after it usually saves money and aggravation.

Can part of a gutter system be replaced instead of all of it?

Yes. It is common to replace the runs on the back of a house where the big roof planes drain and leave a short front porch run alone. The thing worth knowing is that colour lots vary slightly between coil batches, so a partial replacement will not always match perfectly on a sunlit elevation. On the same elevation, replacing the whole run avoids the mismatch.

What happens if the fascia is rotten behind the old gutter?

It gets replaced, because hangers screwed into soft wood will pull free. This is one of the more common change-order items on Orlando gutter work, and it is largely invisible until the old run comes down. A scoped quote states what happens if rot is found and how it is priced, so the number is agreed before anyone is on a ladder with a pry bar.

Is it worth upsizing to 6-inch during a replacement?

Frequently, and replacement is the cheapest moment to do it because the labour is already committed. The upgrade cost is the difference in coil and downspout, not a second job. Whether it is justified comes down to the roof area draining into that run and Orlando rainfall intensity, which is high enough that the question is worth working through rather than defaulting to whatever was there before.

Further Reading

More on this from the field notes

HOA Approval for Gutters in Florida

Florida HOAs can regulate exterior appearance, including gutter colour and profile. Chapter 720 sets out how those decisions have to be made and given.

New Orlando Houses Already Overflow

Builder gutter packages are specified to a build budget rather than to Central Florida rainfall, which is why new subdivisions overflow like 1920s bungalows.

Orlando Gutters Clog in Spring

Southern live oak is semi-deciduous and sheds its old leaves from March into early May, which makes most national gutter maintenance advice wrong for Orlando.

Related Work

Scopes that often go together

Gutter jobs cluster. Once a crew is set up on a roofline with ladders and a truck, adding drainage work or guard to the same visit costs far less than bringing them back for it later.

Seamless Gutter Installation

Aluminum K-style gutter rolled to length on site, no joints along the run

Gutter Guards and Leaf Protection

Screens, micro-mesh, and reverse-curve covers under a Central Florida oak canopy

Gutter Repair and Resealing

Leaking corners, sagging runs, pulled hangers, and separated downspouts

Downspouts and Drainage

Getting the collected water away from the slab instead of just off the roof

Get a price on your gutters

Ring (407) 917-8297, or send the roofline details through the form. Pricing on any gutter job across Orange, Seminole and Osceola counties.

Call (407) 917-8297 Get a free quote